Openers that hum, click, reverse or ignore the remote. We test the motor, logic board, sensors and remotes and repair the opener on site.

Openers fail in a few predictable ways, and each one points to a different part. Before we replace anything, we pull the release and run the door by hand. If the door itself is heavy or binding, the opener is not the real problem.
Often a stripped drive gear, a failed capacitor or a door too heavy from a broken spring.
Usually the safety sensors, a close-force setting or something dragging on the track.
Dead batteries, a lost code or a failed receiver. The wall button tells us which.
Limit settings drifted or the travel module is wearing out.
The two small eyes near the floor have to see each other. A bumped bracket, a dirty lens or sun hitting the receiver will make the door reverse or refuse to close. Wipe the lenses and check that both lights are solid. If they still blink, we realign them, and sensor alignment is free with a service call.

A gear kit, sensor set or logic board on a solid opener is usually worth fixing. When an opener is old, loud, missing safety sensors or needs a board that costs close to a new unit, we will tell you so and price out a new opener instead.

New openers installed, programmed and tested in one visit, including quiet belt drives, Wi-Fi control and replacement of worn-out units.
See service →
Stuck, noisy or crooked garage doors fixed on the first visit. We diagnose springs, cables, rollers and tracks and carry the parts to finish the job.
See service →
Tune-ups from $79: we lubricate, tighten, balance and test the door and opener, with a free safety inspection and sensor alignment.
See service →Tell us what your garage door is doing, and we will get back to you with what it needs and what it costs.
Call Us (215) 930-2922